Returnstar IQBoard PS Bedienungsanleitung PDF herunterladen (Seite 18)

Chapter 7 Operation

7.1 Skills of pressing and writing

Single-click & Double-click: Do not raise the electronic pen or writing pen (finger)

too much (about 1-2mm from the tip to the surface), keep the angle between pen and

surface more than 50º, then press the surface at proper strength. The operation of

double-click on board has the same definition as double-click mouse in Windows,

please make sure you click at the same point.

Drag: Use the electronic pen or writing pen (finger) to press an item and drag it to the

appointed position (during which the pen tip or finger tip should not leave the surface)

Write: If you use IQBoard Software, switch into “Board” mode, and you can use the

writing tools to directly write on the surface. (The writing strength should be the same

as using the normal whiteboard pen.)

Orient: If the pressing position does not match the cursor, please re-orient. If the

deviation still exists, please check the installation of the whiteboard.

Mouse Right Key: Click the surface and hold for 2 seconds to popup the right-key

menu. (IQBoard Software also provides this function. Refer to IQBoard Software User

Manual for details.

Switch back to the Mouse Left Key: If the “Mouse Right Key” function can only be

achieved once, then after you perform the function, the system will automatically

switch back to left key status. If the “Mouse Right Key” function is permanent, you can

select “Mouse Left Key” on the menu of IQBoard Software toolbar or taskbar icon to

switch back.

Note:

1. Please use the 1024*768 resolution. Close all energy saving modes to avoid

performance delay caused by dormancy.

2. To lengthen life span of the battery, please take it out if you will not use the electronic

pen for a long time.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

Keine Kommentare

Returnstar IQBoard PS Bedienungsanleitung Seite 18